When you are doing a garage door repair, and you’ve been able to identify that it is the torsion springs that need to be replaced, it is vital to know where to find the top garage door torsion springs available. It is also crucial to know how to install them properly. In this article, we will go over the basic steps for installing new torsion springs for your garage door.
It should be noted that before starting, you need to have a healthy respect for the mechanics and parts that you will be working with. In other words, exercise extreme caution when doing this repair as you could seriously injure yourself if you do not use the proper tools or are unaware of the dangers involved.
1. Unplug, disconnect, and track
When you first start your repair, you want to disconnect the power to your garage door to avoid any potential hazards. In order to do this, depending on your particular garage door setup, you will need to disconnect the draw bar arm that is attached to your garage door opening mechanism. Once this is done, you want to track where the springs are going to go. This will help keep you from overextending the wind on the spring, and will ensure that the new springs fit properly.
2. Install, secure, and tighten
You want to proceed with the repair by installing the end bearing plates, making sure that the narrower section of the bearing is facing outward towards the garage wall. Continue with securing the end bearing plates to the lag screws and ensure that they are all connected to the correct track angle as they were before you began the repair. Tighten the nuts that are in place to make sure it is attached properly.
3. Measure, predrill, install
Once you have your end bearing plates in place, you need to measure two important distances so that you know where to place the springs. These are going to be the distance from the door to the center of the shaft, and the distance between the garage door and the header. Make sure to write these numbers down as they will come in handy. Predrill the holes that you will need in your anchor bracket so that you know the shaft and torsion springs will all fit properly. Finally, install and secure the anchor bracket to the garage door following your predrilled holes and measurements.
4. Place the new springs on the shaft
In order for your new springs to work properly, they need to be carefully installed on the shaft. Slide one end of the shaft out and install your spring, keeping in mind that each spring has a specific direction it should go in so that you don’t experience issues. For example, there is a left spring and a right spring. Should you get those confused, it could spell disaster for the whole repair. Place the stationary cones on to the shaft along with your springs and then place the end of the shaft back in the end bearing plates. Repeat for the other side if necessary.
There are other steps that you can take to ensure a proper repair, as well as resources that you can access when you visit our website. Be sure to take a look at further instructions, tutorials and all of our great products at top garage door torsion springs.